Dual purpose cutters which can be used for producing either a neat 90° corner joint or a joint for edge jointing boards together. The corner joint is produced by machining one piece with the inside face flat on the surface of the table and the other piece with the inside vertically against the fence. These cutters should only be used in a router table. Available with 1/4"(6.3mm) or 1/2"(12.7mm) shank. Range of timber thickness: 666229 - 9mm to 13mm, 666230 - 10mm to 18mm, 666231 - 13mm to 25mm.
3 November 2016
Short on shankIf cutter performs like other cutters from excaliber then will be very pleased. Issue is cannot use it as shank is too short to use inverted in a table. Cannot understand why cutter designed for table or overhead routers come with short shanks. I have ordered the extension but that is out of stock so job on stop until that is available. There were no set up instructions so had to download the instructions for the equivalent cutter from the Trend web site. Had the shank length been included in the details then I might have avoided it and gone for the mitre lock cutter block for my spindle moulder.