Check our opening hours for the festive season
Win a Gift Card every day until 12th December!
Visit your local store, we have lots of events planned this month
This lightweight trade-rated air tool, which drives 24 gauge headless pins from 12mm to 20mm long, is great for furniture, mouldings, decorative trim and glazing beads. It has a 1/4" BSP female fitting and is suitable for use with smaller compressors. Supplied with a 1/4" BSP Quick Release bayonet fitting. Details of suitable airlines and fittings can be found in the Airline Fittings section.
Firing pins for this pinner are available in two sizes. 18mm piston head size for pre 2015 models (100140) and 22mm piston head size for post 2015 models (101805).
|Load Capacity||100 Nails|
19 November 2016
Does The JobI bought this for fixing glass beading in cabinet doors. While it does work well and sinks the pins nicely it has a very annoying problem. It fires 3-4 pins ok, then the carriage slides open. I'm holding the beads/work piece with one hand then I have to stop work to close the carriage. Further more I have to hold the internal sliding bit in to re close the carriage. This means a simple job takes much longer than it should. I also have the axminster 18g brad nailer which is fantastic, so a little disappointed with this one.
17 September 2016
great value but would pay a little more for certain featureshad this for over 2 years now and its still going well and i punish it laying 10mm parquet as a professional wood floor layer!
14 January 2015
Excellent must have toolHaving struggled with a pin punch and tack hammer for years I thought it about time to buy one of these, there is no going back, I have used this little gun on so many projects it has become an essential tool for me, jobs are now easy that would have been a chore in the past, all I have had to replace is the striker assembly, and I have fired it thousands of times.
18 August 2014
Good…but……….I bought this and did a job with it and thought it was brilliant..but the next couple of times I used it it wouldn't drive the pins home.I adjusted my compressor pressure but that did not help. I had bought a spare firing pin with the gun (as I wondered why they were sold so prominently !) replaced that and it was back to brilliant again. I think the firing pin is softer than the s/s headless pins. Good value machine, but buy a spare firing pin if you are using it a lot. Geoff
25 January 2014
Good bit of kitI did wonder before I purchased this how good would it be for the money, well I shouldn't have worried. It leaves a virtually invisible dot, I have just pinned in some white mouldings onto the bottom of some skirting board to hide some an finish on some laminate floor and you can hardly see the mark. Definitely recommend it for the money. I have only scored three on features as it doesn't really have any lol.