Axminster Depth Gauge & Protractor
Axminster Depth Gauge & Protractor

NOW £3.96

Normally £6.40

(£3.30 Ex. VAT)

Axminster Depth Gauge & Protractor

Code: 800287

  • For measurement and transference of angles
  • Gauge for measuring the depth of holes or recesses
  • Dual calibrated graduated rule
  • 150mm(6") maximum depth

Save £2.44

Last Few

NOW £3.96

Normally £6.40

(£3.30 Ex. VAT)

Out of stock

Sorry, this product is no longer available.

See Alternative Options

Collect in store, we'll confirm your reservation within 1 hour.

Check stock at your local store

Chosen store -

Loading stock for

In stock - collect from in 1 hour

Low stock - collect from in 1 hour

Out of stock at

Change store
Learn how it works

We're commited to selling high-quality products, however we also know thats there are times when you need to exchange or return an item.

  • No quibble 30 day returns policy
  • Arrange your return online, in-store or by phone
  • Simple and easy returns process
Find out more
Description

In Detail

A very handy dual-purpose tool which can be used either for the measurement or transferring of angles or, with the graduated rule in the right angle position, as a gauge for measuring the depth of holes or recesses. The rule is dual calibrated in metric and imperial and the maximum depth is 150mm(6").

Reviews (2)

Customer Reviews

Overall rating 1 out of 5 based on 2 reviews

Newest Customer Reviews

Quality
Features
Value

Ian George

26 August 2016

Almost worthless

There is so much slop in the pivot and rule slide that its just not credible as an angle gauge. The lock off doesn't work very well either and, as the previous reviewer says, scope for measuring angles under 20 degrees is a bit limited. Doesn't look quite like the picture either.
Features
Value
Quality

Ron

15 May 2015

Not A Good Buy

I bought this as a measurement tool where I need to know and mark angles of less than 10° with reasonable accuracy and this particular protractor/depth gauge fails completely. The scale on the left bottom is 2.58 mm away from the edge and on the right side it is 1.7 mm away from the edge. The rule is not nice and clear as in the picture above, but is rather difficult to read and in addition it appears to have something like rust on it as well. The mm scale on the reverse side is much better though, but still with some discoloration. I set the depth gauge to 1 inch and measured it with the depth gauge on my vernier caliper and it was only 0.945 inches. This tool is meant to be used as a measuring device and it fails big-time. I don't know at this time whether to bin it or send it back and get another one or different make, but once burnt....

Alternative Options

People Also Looked At