A range of 3 low cost drill vices suitable for use in any workshop. 75mm vice with fixing width of 110mm, 100mm vice with fixing width of 135mm and 125mm vice with fixing width of 165mm. Cast in quality grey iron with machined face jaws, the elongated slots on either side enable the vice to be bolted down to the table.
30 June 2013
It's okI've had this vice for 3 or four months now. It's fine for holding anything square or rectangular in section but not so great at holding anything which is round or wider at the top due to the amount the movable jaw can rock. The movable jaw is held on the vice by a thin plate screwed to it's base. This bends over time and the more you tighten the vice the more the plate bends and the more the jaw rocks. As a result of this I've recently had a 12" length of 1" bar work lose out of the vice whilst drilling.