A thoroughly modern design of mobile dust extractor with a cartridge filter included as standard. The excellent performance comes from careful matching of the motor, impeller and housing, resulting in a quietly efficient machine able to extract chips and medium sized dust from almost all Trade specification machinery. An alloy impeller is fitted to reduce the risk of sparks and the extra large cartridge filter has a rating of 1 micron @ 100% capture rate. A large capacity plastic waste sack and quick release straps are included. A comfortable tubular handle, steel rear wheels and front castor wheels are provided for easy mobility. The cartridge filter increases the potential use of this machine to include sanders as well as the normal range of saws, planers etc. The filter is easy to keep clean with the top mounted crank handle, the extra surface area means that the overall airflow is not reduced. Overall, a fine, modern extractor for any trade workshop. Hose not supplied. N.B. 16amp supply is required.
|Air Flow||2,250 m³/hr @ 175mm, 1,200 m³/hr @ 100mm|
|Bag Capacity||170 litres|
|Hose Diameter||1 x 175 mm or 2 x 100 mm|
|Noise Level||77dB @ 3M|
|Overall L x W x H||1,100 x 680 x 1,750mm|
|Particle Size||1 micron @ 100% capture rate|
|Power||1.5kW 230V 1ph|
6 April 2017
message to alan about mounting my extractorit is a YouTube video on how i mounted it to the wall well most of a video as the cam went off near the end. Look up 'installing an Axminster extractor to a cyclone'. this was how i did it.
23 February 2017
Good - but needs an upgradeReasonable value extractor and could easily cope with an in-line cyclone. Mine came with a 13A household plug which kept blowing the fuse on start-up. Changed to a 16A plug (I have these outlets in my workshop) and put a slightly longer, higher-rated cable on and all seems well now. Bit tricky to re-wire as you'll need 6mm spade connectors and correct crimping tools etc. I had these but a bit of a faff if you don't. Would still recommend overall and buy again.
30 December 2016
very goodOnly bought this afternoon but tried out earlier and very impressed, seemed quieter than i was expecting. will eventually hook up to permanent system but for now will use mobile. be interested to know how Paul mounted his on a wall.
25 July 2016
quite impressedmost of my workshop (semi pro) is axminster trade and most of it is good for the price. i had to upgrade my extractor from a HPLV vacuum type to a more suitable HVLP type to cope with my 12 inch P/T and panel saw, i was skeptical at first as i weren't expecting very much for some reason. i rigged up a 100mm flexi hose and threw some shavings and dust and general workshop crap on the floor, the hose was nearly 5m long and all convoluted, i had convinced my self that it would not cope with the shavings, with in seconds it had all gone and was in a bag under the filter, spinning frantically, some other bits n bobs that were on the floor also got sucked up. that was just one 100mm hose over a 5m run. my old vac extractor could not cope with the waste the P/T made and spat out shavings everywhere, this sucked it all up and all the waste the other one left behind. it is my intention to run 150mm ducting and a stand alone cyclone, i wall mounted the extractor on the wall above the cyclone and ditched the trolley. i am now expecting good things from this when the system is fully up and running.