Check our opening hours for the festive season
Win a Gift Card every day until 12th December!
Visit your local store, we have lots of events planned this month
A very useful power feed system for the X axis to provide a smooth, variable speed drive to the traverse of the table. This will enable control of the cut finish to a much greater extent than achievable by hand. With simple controls for left/right movement, auto stop in any position on the table provided by movable stops, overload protection and a fast traverse button giving 40" per min speed. Simple to fit and powered by a standard 230V three pin plug, so no wiring is required. N.B. For ZX series mills only.
|Feed Speed||0 - 180|
7 October 2016
Confusing manual spoils an excellent productThe process of assembling and fitting the power feed should have been straightforward, but was let down by a totally inappropriate instruction manual provided by the (Chinese) manufacturer. Only after wading through 17/18 pages of the manual was it apparent that the correct unit had been supplied. It would have helped if Axminster had produced their own fitting instructions, and the catalogue illustration provided far more helpful information about how the power feed should be fitted. The actual fitting took about 25 minutes and the feed worked perfectly first time. No time yet to see how it performs doing serious milling tasks, but I'm confident it will do a good job.
23 April 2015
Great to use.I have recently fitted this power feed to my RF 31 Mill Drill. Job was done in less than half an hour. But make sure your lead screw dial is on the right hand side of the table. Well worth the money!!!!!
7 September 2010
Power FeedJust fitted this power feed to my ZX25 Mill and have done a faiir bit of machining with it. It `does exactly what it says on the tin`. Easy to fit ( change handwheel for gear, clamp to table, set clearence on drive gears, fix limit switch and stops, plug into 240v power supply, switch on and go). easy to use and makes machining straight forward.