Check our opening hours for the festive season
Win a Gift Card every day until 12th December!
Visit your local store, we have lots of events planned this month
This flush mounted stop can be raised when needed up to 1/2" proud by means of a spring loaded wing bolt. The serrated jaw holds even thin stock firmly. Made from cast alloy it is non rusting and soft enough not to chip the plane iron should accidents occur. It is 1.1/2" wide and 2.1/2" long and can be mounted into any bench thicker than 7/8", and is secured by two screws hidden under the jaw. A most useful addition to any woodworker's bench.
24 November 2013
Cheap and good!This is a good product which I wouldn't hesistate to recommend but I agree with the previous reviewer that the edges which contact the workpiece are very sharp and would dig into wood without a protective bit of scrapwood in between the two- I might file them down to sort this.
Bob in Stone
15 March 2013
Bench StopI liked this product - it does what it says in the ad. Two points though, no fitting screws were included and the serrated teeth on the stop are too sharp to use with your workpiece, use a bit of scrap in between to avoid digging into your timber. Otherwise a useful bit of kit.