Check our opening hours for the festive season
Win a Gift Card every day until 12th December!
Visit your local store, we have lots of events planned this month
Accurately cuts small items of metal, wood and plastic. Table movable through 45°, allowing mitre cuts. Workpiece is fastened tightly and accurately by means of the integrated clamping device. Clamp jaws 27mm wide and maximum workpiece diameter 20mm. Depth of cut to 13mm. A special slot is provided to clamp H0 model tracks. The fence accepts lengths up to 140mm. Five ceramic cutting discs 50 x 1 x 10mm are also included suitable for cutting steel, non-ferrous metals as well as small wooden or plastic rods. Peripheral speed 20 m/sec.
4 December 2014
Briliant!I bought this to cut carbon fibre rods and tubes.
15 November 2014
4,5 starsI have both, KGS 80 and KG 50. I use KG 50 for small diameter brass rods 1 - 5mm. I try cut 2mm rod on KGS 80 but ripped out it from vice because is too small for v-cut in vice jaws. So i bought KG 50 - counter to KGS 80 is very quiet. For brass cutting i use proxxon saw blade NO28 020. It cuts fast and clean. If you want save money dont buy KG 50 instead KGS 80 - each have their purpose.
28 May 2014
ok for wood and plasticI have one, used the metal blade from the chop saw. Goes thro wood and plastic ok. Fibre blade ok for del size tubes and bar.
6 September 2013
Terrible. Just terrible.Barely a step up from something in a kids toolbox playset to be honest. I bought it because it looked very useful for series cutting of delrin rods but even on 7mm diameter plastics the cut is painfully slow and the results not terribly good. If there's one positive it's that it is very quiet but that's hardly surprising when the motor has all the grunt and power of an asthmatic hamster. I expected more from Proxxon.
18 April 2013
KG50: good for cutting nails?I needed something to cut aluminum bars (12mm) and didn't want to spend €200 for the KGS80... the specs of this one looked promising so I ordered it. Got it this morning, put the "blade" on and tried cutting the bar.