Check our opening hours for the festive season
Win a Gift Card every day until 12th December!
Visit your local store, we have lots of events planned this month
Especially developed for the UJK Pocket Hole Jig, this extraction outlet can be simply fitted so that you can attach a vacuum for extraction. Outlet diameter: outside 42mm, inside 35mm.
|Model||UJK Pocket Jig Extraction Outlet|
9 October 2016
Good idea but poor execution and too expensive£19.45 for a plastic tube and two screws? This is surely not value for money. The fitting of the extraction outlet was not straight forward. There is a shallow channel on the flat side which accommodates the edge of one of the black upright supports on the jig. The channel is however not quite deep enough so that when tightened it prevents the orange guide block from up or down adjustment. Also the knurled bolt head which secures the guide block is difficult to turn with the extraction outlet in position. Both of these problems can be worked around by removing the extraction outlet to make adjustments for different thicknesses but why should this be necessary? I solved the first issue by deepening the channel using a Dremel cutter but again why should this be necessary? As an extraction outlet it works perfectly but so it should - it's not rocket science is it?
7 September 2013
Best Pocket Hole Jig I've usedUsed this with the optional vacuum connector you won't find a better pocket hole jig than this. It gives fast, clean cuts that are perfecltly aligned and it's solid and well-engineered.