Check our opening hours for the festive season
Win a Gift Card every day until 12th December!
Visit your local store, we have lots of events planned this month
Traditionally used for the rapid trimming of plugs and dowels flush with a surface, these flush cutting saws can be used where you want to cut off a projection without damaging the surrounding or adjoining face. The Japanese tooth pattern blade cuts aggressively (on the pull stroke), but does not mark the surface that it is cutting next to. The thin blade is flexible and can be pressed flush to any surface, yet is rigid enough for good control. The saw is available with teeth cut on only one edge with no set or in a double edged style that cuts from either side with the teeth set in one direction. Each is about 290mm long with 120mm of blade. These work like a charm.
26 December 2014
Just ExcellentWe use 35mm plugs on our workbenches this little dude cuts them with a breeze without marking the wood
4 May 2012
'sawsomeGreat product from the Veritas stablet. Does a neat job very quickly without marking the timber. With the teeth set on one side the cut tends to rise a little as outlined in the instructions, so I tend to cut from both sides to half way, reducing cleaning up time to a minimum. Great value too especially the double edged version.
21 June 2011
Good for precision jobsVery good saw, cuts flush and without any marks. Takes some time to get used to (and remember!) pull action (japanese style). The saw feels a bit flimsy but I suppose it's meant to be that way to enable cuting in tight corners. I've tried to use it to cut pegs 12mm made of seasoned larch timber and it was not very fast. Perhaps 22Tpi was to fine for the job.