Turn your morticer into a small, useful pillar drill. Replace the chisel and bit with this 1/2" capacity drill chuck, Supplied complete with a 25mm (1") shank bush to fit most morticers.
|Shank Diameter||1" (25.4 mm)|
9 November 2018
I had to fix it 10+ years ago, and will now replace the chuck.I bought this over a decade ago and have been using it ever since. It has made an 'undersized for my needs' morticer into a useful pillar drill.
23 September 2016
Very good accessoryI have been using this for well over a year now. The morticer has had more use as use as a drill stand than as a morticer. It is essential to lubricate the guide bush as with any other brass bushes and it has proved to be accurate with all sorts of materials. An excellent accessory which more than justifies the cost of the morticer.
23 April 2016
Too SoftHaving purchased these before i had little faith with previous models lasting a few months. unfortunately this skewed literally on day 1. constructing a new table and fence I'm positive the work was square and minimal depth with a 12 mm forstner bit, almost immediately the vibration began and checking the adaptor was central and the collet was secure i continued needing to apply lubricant to the shaft which stopped the vibration. on my 10th hole the work was beginning to rotate when i applied the bit and then the work was hitting the fence and it was plain to see the shaft was no longer straight and the collet had jammed and cut a groove in the steel.