A handy little spray gun, useful for spraying small areas of work or modelling projects. Can handle almost all finishes including water based acrylic enamels. Easy to use and comfortable, especially in the smaller hand. Fitted with a stainless steel paint flow needle, air fan control, paint regulator and 125ml suction feed cup. 1/4" BSP male inlet fitting. Takes quick release bayonet fitting 100314 or 410250 (swiveling).
|Air Consumption||2 - 5 cfm / 56.6 - 141.6 l/m|
|Cup Capacity||125 cc|
|Operating Pressure||40 to 70 psi / 2.8 to 4.8 bar|
|Type of Feed||Gravity|
30 January 2016
You get what you pay forWas given one for Xmas 2014, first used in anger Jan2016. When it worked it worked ok. However it is not very well made.
24 September 2011
Mini Touch Up Gun.What a brilliant bit of kit. Usually use two spraycans per picture frame at £6.99 ea. Just done 3 frames - paint cost minimal (£8 per litre) - so saved £40 on first job. Simple to use. Guess airflow n set stop. Then open up Paint screw till desired finish achieved on scrap plywood. Paint about 80% white spitit 20%. Bargain !!!! ( knob at base set open but think it controls air pressure from tank - set on then ignore.) Bobtheframer
20 September 2011
Mini Touch Up GunWell, ordered yesterday and arrived this morning ! Brilliant service as usual.