A 60mm faceplate to replace the chuck allowing irregular shaped items to be fitted. Three slots allow clamps to be used to secure the item.
Mr Graham Lewis
5 January 2010
Worth buyingIt doesn't look much but you can quickly adapt it as it's made from cast iron. Make yourself some sliding nuts for the grooves - I used a piece of 1/2" bar drilled and tapped M6x1 with a 7mm long 7.95mm diameter sleeve section and a 3mm long flange. I then turned fine grooves at 5mm diameter increments to aid alignment. Finally I drilled and tapped 2 M6 holes in each web, one at 35mm diameter and one at 55mm. Cut clamps to fit from offcuts of flat bar. It is now a very versatile little holder.