There are certain situations in woodworking when work pieces defy conventional clamping methods. Finding a solution can often be a time consuming compromise and not always satisfactory. UJK Technology has come up with a unique answer to the age-old problem of clamping something onto a flat surface using side pressure. You may be lucky enough to own a bench with dog holes and a tail vice. However, sooner or later there will be an odd shaped or thin work piece that presents a problem.
The Surface Cam Duck Clamp is a simple solution and, as they say, the simplest is often the best. CNC machined from 12mm thick solid compact laminate, these low profile Ducks will last a very long time. You can reuse them time and time again, whenever the need arises.
Effectively a cam is a wedge wrapped around a pivot. In this case, the pivot is the screw hole in the Duck’s body. Simply screw as many Ducks as required into position onto your bench or work board. Use the beak to tighten the cam and then fix with a screw in the eye of the Duck.
The double fixing ensures the Ducks remain firm even when subjected to vibration from sanding or routing. Use these Surface Cam Ducks for planing, scraping, carving, sanding and for any irregular shaped object. Sold as a pack of two.
11 April 2018
fantasticI purchased 2 pair of these cam clamps to use for clamping on my cnc bed, they are great really well made and solid. I did drill a third hole closer to the centre on the body for the pivit point as i found the held better without the need for the second screw. If ujk made a straight piece out of the same material for use as a fence id buy a couple of the too in a flash
15 March 2017
I really like itWaaw amazing